To ensure the safe operation of the device it is recommended to read this user manual completely before starting to use the device.

  • RF Frequency: 433MHz
  • Power supply: 230Vac
  • Output: 2 Din-8 male/female connector
  • Maximum loads: 30V – 3A (90W cos=0,8)

The Enabler Bed allows controlling the movement of adjustable motorized beds. With this receiver you can control the movement to raise / lower the head and foot of the bed.

Enabler bed

Fig. 1. Enabler bed.


You can activate the Enabler remotely using any of the BJ System’s remote controllers

To do this, connect the bed’s remote controller to the Enabler’s connector for the remote (fig. 1). Then connect the connector for the bed’s engine to the engine where the remote was previously connected.

Enabler connection

Fig. 2. Enabler connection.

IMPORTANT: Before connecting the Enabler, check in this manual the technical specifications for the device and the bed.

CAUTION!: An error in the connections may cause serious damage to the device or the installation, or harm to the operator.

To control the Bed Receiver with the BJ system controls, follow the next steps:

1. The codes assigned to the receiver are given by Table 1. If for example the position 0 is selected (default position), the code 129 will raise the head of the bed and the code 130 will lower the head. The codes 131 and 132 will do the same with the foot of the bed. The selector position can be modified only by a technician (it is placed inside the box). In the case of not having RF code selector, the list of codes corresponding to position 0 will be taken.

2. Program on the BJ System’s remote controller the RF code assigned in Table 1, depending on the position of the selector. See the controller’s user guide to learn how to program the RF codes.

Table 1.


3. The Enabler will activate/deactivate the load when the programmed button in the controller is pressed.

The bed movements will be carried out depending on the selected operating mode:

Dead man’s mode (codes from 129 to 132 or from 135 to 138): The bed will move while the remote’s button is pressed.

Pulse mode (codes from 141 to 144 or from 147 to 150): Once the remote’s button is pressed, the bed will move during 2 seconds and then will stop. To activate the movement, the remote’s button must be pressed again.

To change the code in the selector, disconnect the enabler from the power supply, wait five seconds and reconnect the circuit.

The device can be cleaned using a damp soft cloth. Always carry this operation out with the enabler disconnected.

In the event of a fault in the enabler, do not handle it and contact your distributor.

Waste electrical products should not be disposed of with household waste!

Dispose of the waste product via a collection point for electronic scrap or via your specialist dealer.

Put the packaging material into the recycling bins for cardboard, paper and plastics.

Within the statutory warranty period we undertake to rectify free of charge by repair or replacement any product defects arising from material or production faults.

Any unauthorized tampering with, or modifications to the product will annul this warranty.

This product complies with the essential requirements of the Directive 89/336/EC.

The Declaration of Conformity can be downloaded at BJ-219 Conformity.pdf

If, despite of correct handling, faults or malfunctions occur or if the product was damaged, please contact us at the address below:

BJ Adaptaciones
C/ Mare de Déu del Coll, 70, Bajos
08023 Barcelona, Spain
Phone: +34 93 285 04 37
Fax: +34 93 553 56 34